Spendor A6 Floorstanding Speakers In Rare Wenge Finish

Free Shipping on *ALL* Electronics (Excluding Speakers, Contiguous 48 US States Only)

These feature the most gorgeous finish I have seen on Spendors which was a rare option.

Typical soft laid-back yet super engaging sound as you'd expect from a Spendor.

100W of solid state amp should drive these nicely without drama or strain.

Featuring super high-end German made WBT speaker connectors.

In overall very good condition with little signs of use.

Click below to add our recommended matching cables from Kimber Kable, all brand new as SkyFi is an official Kimber dealer.

Kimber Kable - Speaker Cables - Better

Kimber Kable - Speaker Cables - Best

More from Spendor
Standout Features:
• Fourth generation 'linear flow' port gives clean articulate bass
• New Spendor 18cm drive unit with large excursion motor
• New 29mm wide surround tweeter for extended response
• High grade crossover network with gold conductors
• Silver plated pure copper internal cables throughout
• WBT high copper alloy binding posts on the rear
• Spendor 'dynamic damping' to minimise cabinet resonances
• High rigidity stabiliser plate system for solid floor mounting
• Modern finishes including Oak and Wenge

Description
2-way floor standing loudspeaker

Enclosure type
Spendor linear flow reflex

HF drive unit
29mm wide-surround dome with fluid cooling

MF / LF drive unit
Spendor 180mm ep38 cone

Sensitivity
88dB for 1 watt at 1 metre

Crossover point
4 kHz

Frequency response
53 Hz to 20 kHz ± 3dB anechoic

Typical in-room response
-6dB at 43 Hz

Impedance
8 ohms nominal

Impedance minimum
6.0 ohms

Power handling
200 watts unclipped programme

Terminals
WBT 4 way binding posts single-wired

Cabinet Dimensions (H x W x D) EACH:
34.45 x 7.56 x 11.02
(875 x 192 x 280mm)

Available Finishes:
black ash, cherry, light oak, wenge, dark walnut

Weight - EACH:
39.68 lbs.
(18kg)

The SkyFi Testing Process for Speakers:

Our speaker evaluation process starts with a visual inspection of all drivers. We are looking for damaged or deteriorating woofer surrounds, dented tweeter domes, and cone damage. We also inspect the speaker connection points for loose or broken connectors.

After the initial visual inspection we connect the speakers to a reference amplifier with our preferred test tracks. With the speakers placed with proper distance we listen to each driver to make sure that they are producing the intended frequencies with no signs of distortion or rattle. During listening tests with test tracks we check for proper stereo imaging and bass response at various listening levels. If there are any audible signs of issues, the speakers are taken to the bench where we perform a frequency sweep to isolate the issue so that it can be resolved by component repair or replacement.